User's Manual

Installing the 100W-R and 100WP-R Endpoints
TDC-0951-001 100W-R and 100WP-R Datalogging Water Endpoint Installation Guide 18
Proprietary and Confidential
The final installation will resemble the image below after the tamper seals are installed.
Note A tamper seal is fully seated when the top of the tamper seal is approximately 1/16-inch below the
top of the screw recess.
3. Secure the cable to the meter pipe with a cable tie.
4. Push excess wire up between the back of the endpoint and the face of the adapter plate.