User's Manual

Installing the 100W-R and 100WP-R Endpoints
TDC-0951-001 100W-R and 100WP-R Datalogging Water Endpoint Installation Guide 24
Proprietary and Confidential
Required Tools and Hardware
Remote mount installation requires the following tools and hardware:
Remote Mount Kit (CFG-0771-021 or CFG-1300-003) includes the back plate, tamper seals, and
mounting screws)
Nut driver or similar tool
Phillips screwdriver
Drill and bits for mounting surface and screw size
To install on a flat surface
1. Select an installation location.
2. Using a back plate template, drill three pilot holes into the wall or other surface. The two bottom holes
should be level.
3. Screw a mounting screw for the lug slot into the surface, leaving approximately 1/8-inch of the screw
protruding. The lug slot should slide over the screw with a tight fit.
4. Slide the endpoint lug slot onto the mounting screw, pushing the endpoint upward until the screw head is
all the way into the slot.
5. Screw the endpoint to the wall using the remaining two mounting screws.