Manualshelf

User's Manual

ManualsBrandsItron ManualsElectronicsAMR transceiver device for reading utility meter
11121314151617181920
Initializing, Connecting, and Programming
TDC-0951-001 100W-R and 100WP-R Datalogging Water Endpoint Installation Guide 9
Proprietary and Confidential
Programming
100W-R
The 100W-R endpoint’s consumption values are not programmable. (Programmable parameters include
values like ID and register type.)
Programming the 100W-R will move the endpoint into the specified operating mode.
If the 100W-R endpoint is not programmed, the endpoint will attempt to read the register every hour and
will wake up into default Mobile Handheld mode when a register is found.
100WP-R
Use an FC200SR or FC300 with SRead handheld running Field Deployment Manager (FDM) software and
your utility's programming configuration file to program the 100WP-R.
Note Do not program the 100W-R or 100WP-R endpoint until it is connected to the water meter register.
Refer to the Field Deployment Manager Endpoint Tools Mobile Application Guide (TDC-0934) for
programming information.
After programming, the endpoint enters the selected operating mode and begins bubbling-up specified
messages at the selected rate.
Caution
The FC200SR and FC300 with SRead are the only handhelds that support programming for
the 100WP-R endpoint.
The endpoint and programmer should be a minimum of 12-inches apart while programming.
Do not place the programmer antenna directly on the endpoint.
Verifying 100W-R and 100WP-R Endpoints Operation
Use one of the following handheld computers to verify the endpoint is correctly recording consumption data.
FC200SR
FC300 with SRead
Caution
Each handheld radio requires special setup and configuration parameters to
successfully read and program 100-series products. Refer to the respective meter
reading application for specific instructions.
Do not use ReadOne Pro, FS2PN and FS3PN readers to read the 100WP-R. These
readers do not operate their receivers long enough to reliably capture a 100WP-R
transmission.
Refer to the user guide for your programming device (see Related Documents on page 2) and data collection
application for more information.