User's Manual

Installing the 100W-R and 100WP-R Endpoints
TDC-0951-001 100W-R and 100WP-R Datalogging Water Endpoint Installation Guide 11
Proprietary and Confidential
To attach an encoder/pulser only backplate
1. Fold the completed encoder/pulser wire connections into the endpoint housing where the instructions
PLACE GEL CAPS AND EXCESS WIRE IN THIS POCKET are stamped.
2. Route the register cable through the single backplate cutout.
3. Align the endpoint backplate with the mounting screw holes. Verify the Itron logo and arrow point up.