User's Manual

Installing the 100W-R and 100WP-R Endpoints
TDC-0951-001 100W-R and 100WP-R Datalogging Water Endpoint Installation Guide 12
Proprietary and Confidential
4. Insert a backplate mounting screw in one corner and tighten two to three turns. Insert the remaining three
screws, tightening a few turns.
5. Completely tighten all the screws in an alternating fashion.
To attach an encoder/pulser and leak sensor backplate
1. Fold the completed encoder/pulser and Leak Sensor wire connections into the endpoint housing where the
instruction PLACE GEL CAPS AND EXCESS WIRE IN THIS POCKET is stamped.