User's Manual

Installing the 100W-R and 100WP-R Endpoints
TDC-0951-001 100W-R and 100WP-R Datalogging Water Endpoint Installation Guide 13
Proprietary and Confidential
2. Route the register cable through the appropriate backplate cutout and the Leak Sensor cable through the
remaining cutout.
3. Align the endpoint backplate with the mounting screw holes. Verify the Itron logo and arrow point up.
4. Insert a backplate mounting screw in one corner and tighten two to three turns. Insert the remaining three
screws, tightening a few turns.
5. Completely tighten all screws in an alternating fashion.