User's Manual

Chapter 2 American Meter Installation
18 2.4GZ OpenWay Gas Module Installation Guide
4. Install and tighten all OpenWay Gas Module assembly mounting screws, working in a
diagonal pattern as shown below. Tighten the mounting screws to 15 to 20 inch-
pounds of torque. Use the 1/4 - 20 x 5/8-inch screws for this step (you can use the
original mounting screws if they were the correct size and not corroded; otherwise,
use the correct size Replacement Screws on page 6).
3
41
2
5. Place a new tamper seal over two of the mounting screws as shown below.
1
2
6. Press the new tamper seals into place using the 11/32-inch nut driver (or another
similar blunt tool).
7. Complete any necessary paperwork. Make sure no excess material is left on the
customer premises; dispose of it properly.