User's Manual

Chapter 3 Sensus Meter Installation
28 2.4GZ OpenWay Gas Module Installation Guide
To Attach the OpenWay Gas Module to the Meter
1. Gently place the OpenWay Gas Module assembly against the front of the meter as
shown. Make sure all four mounting screw holes in the 2.4GZ line up with the
corresponding holes on the meter.
2. Insert the top-right cover mounting screw. Tighten the screw just enough to hold the
2.4GZ in place. Use the 10 - 24 x 5/8-inch screws for this and the following step (you
can use the original mounting screws if they were the correct size and not corroded;
otherwise, use the correct size as described in Replacement Screws on page 21).