Installation Guide
Table Of Contents
- Cellular 500W Module Pit Installation Guide
- Contents
- New in This Document
- 1 Introduction
- 2 Initialization, Connection, and Programming
- 3 Cellular 500W Pit Module Installation
- 4 Accessory Installation
- 5 Completing Gel-cap Connections Using the Itron Splice Kit
- A Troubleshooting
- B Important Safety and Compliance Information
Required Tools and Hardware
This mounting method requires the pit lid mounting hardware (CFG-1601-001).
Note: Pit lid mounting is not intended for applications involving vehicular traffic.
This section provides the instructions to install the pit module in a pit lid with a hole using the
pit lid mounting bracket. Verify that you have the following items to complete the installation.
1 Pit lid with a pre-drilled hole User-supplied
2 Through-the-lid retainer clip CFG-1601-001ξ
3 Retainer clip collar
4 Cellular 500W Pit Module
Note:ξThere are variants of the Cellular 500W, some of which
do not include the middle red port.
ECW-1700-001
Cellular 500W Module Pit Installation Guide 3 ξCellular 500W Pit Module Installation
October 13, 2021 815-0617-00 REVξ000 Itron, Inc. Page 20 of 40
DRAFT