Installation Guide
Table Of Contents
- Cellular 500W Module Pit Installation Guide
- Contents
- New in This Document
- 1 Introduction
- 2 Initialization, Connection, and Programming
- 3 Cellular 500W Pit Module Installation
- 4 Accessory Installation
- 5 Completing Gel-cap Connections Using the Itron Splice Kit
- A Troubleshooting
- B Important Safety and Compliance Information
β
If you cannot drive the rod in enough to equal the necessary spacing, cut the
remaining rod length to the proper height using an abrasive cut-off tool.
Caution: Cutting fiberglass creates dust particles. Practice proper safety
precautions when using cut-off tools to prevent exposure to fiberglass dust
particles.
β
If the rod is the correct depth but remains loose in the soil, replace the rod with a longer
version.
6. The top of the rod must be 3-1/2 inches below the bottom of the lid. Place the module on
the rod. Completely insert the rod into the pit module's rod mount hole. Do not force the pit
module onto the rod. If the pit module does not slide freely on the rod, remove the pit
module and examine the pit module rod hole and rod for burrs or obstructions.
7. You may secure the pit module to the rod with a self-drilling screw through the hole in the
top of the pit module's rod mount cavity.
Cellular 500W Module Pit Installation Guide 3 ξCellular 500W Pit Module Installation
October 13, 2021 815-0617-00 REVξ000 Itron, Inc. Page 24 of 40
DRAFT