Installation Guide
Table Of Contents
- Cellular 500W Module Pit Installation Guide
- Contents
- New in This Document
- 1 Introduction
- 2 Initialization, Connection, and Programming
- 3 Cellular 500W Pit Module Installation
- 4 Accessory Installation
- 5 Completing Gel-cap Connections Using the Itron Splice Kit
- A Troubleshooting
- B Important Safety and Compliance Information
8. Connect the register (black connector, 1) and optional telemetry device (blue connector, 2)
into the appropriate connection.
9. Turn the connector locking ring to secure the connection.
Caution: Turn only the locking ring. Turning the entire connector could damage
the connector pins.
10. Installation is complete when the pit module is perpendicular to the underside of the lid.
The pit module must not contact the pit structure or lid.
Caution: Verify that the pit lid does not touch the pit module when the lid is
replaced. There must be a 1 to 2 inch space between the top of the pit module
and the bottom of the pit lid. If the pit module is installed too high or too low, or is
touching any of the surrounding surfaces, adjust the installation as necessary.
Cellular 500W Module Pit Installation Guide 3 Cellular 500W Pit Module Installation
October 13, 2021 815-0617-00 REV000 Itron, Inc. Page 25 of 40
DRAFT