Installation Guide
Table Of Contents
- Cellular 500W Module Pit Installation Guide
- Contents
- New in This Document
- 1 Introduction
- 2 Initialization, Connection, and Programming
- 3 Cellular 500W Pit Module Installation
- 4 Accessory Installation
- 5 Completing Gel-cap Connections Using the Itron Splice Kit
- A Troubleshooting
- B Important Safety and Compliance Information
Leak Sensor Installation
Installation of the Leak Sensor with a Cellular 500W Pit Module requires the Leak Sensor with
an inline connector (Itron part number LDS-1601-001). The Leak Sensor connects to the
telemetry connector on the pit module.
If the Leak Sensor five foot cable is not long enough to reach the Cellular 500W Pit Module, an
extension cable is available from Itron (CFG-0151-404). The maximum cable length between
the Leak Sensor and the Cellular 500W Pit Module should not surpass thirty feet.
Caution: If the pit module is installed to enable communications for the Leak
Sensor but a register is not connected, replace the register connector's cap with the
environmental cap removed from the blue telemetry connector to protect the
register connector.
Cellular 500W Module Pit Installation Guide 4 Accessory Installation
October 13, 2021 815-0617-00 REV000 Itron, Inc. Page 33 of 40
DRAFT