Installation Guide
Table Of Contents
- Cellular 500W Module Pit Installation Guide
- Contents
- New in This Document
- 1 Introduction
- 2 Initialization, Connection, and Programming
- 3 Cellular 500W Pit Module Installation
- 4 Accessory Installation
- 5 Completing Gel-cap Connections Using the Itron Splice Kit
- A Troubleshooting
- B Important Safety and Compliance Information
5. Insert the connectors and wires into the splice tube until the connectors and wires are
completely immersed in the non-conductive gel material.
6. Separate the cable wires to the sides and close the splice tube cover.
7. Remove any leftover materials from the customer premises.
Cellular 500W Module Pit Installation Guide 5 Completing Gel-cap Connections Using the Itron Splice Kit
October 13, 2021 815-0617-00 REV000 Itron, Inc. Page 36 of 40
DRAFT