Installation Guide
Table Of Contents
- Cellular 500G Module Remote Mount Installation Guide
- Contents
- New in This Document
- 1 Introduction
- 2 Mounting
- 3 Programming
- 4 Specific Meter Manufacturer Installation
- 5 Using Gel-cap Connectors to Complete Wiring Connections
- 6 Optional Sealant Application Instructions
- A Important Safety and Compliance Information
- U.S. and Canadian Patent Numbers
- USA, FCC Part 15 Spectrum Compliance
- Modifications, Repairs, Installation, and Removal
- Canada, ISED Spectrum Compliance
- RF Exposure (FCC/ISED)
- Transportation Classification
- Lithium Battery Safety
- Equipment Repairs
- Intrinsic Safety
- Electrostatic Ignition Hazard
- Module Cleaning
- Do Not Drop
Itron part number Description
CFG-0005-003 Pipe mount kit contents:
■ 2 band clamps
■ 2 tamper seals
■ 1 pipe bracket
■ 2 cable ties
■ 1 adapter plate
■ the following screws:
1. SCR-0215-001 (2) #8-16 by 1/2 inch slotted pan-head
tapping screw, corrosion-resistant steel. Attaches the
adapter plate to the pipe bracket.
2. SCR-0215-002 (2) #8-16 by 1 inch slotted pan-head
tapping screw, corrosion-resistant steel. Attaches the
module to the adapter plate.
Completing the Installation
1. Remove the pipe bracket and clamp from the kit.
2.
3. Push the end of the clamp’s band through the holes in the pipe bracket as shown.
4. Place the band clamp around the pipe. The band will loosely wrap around the pipe.
Cellular 500G Module Remote Mount Installation Guide 2 Mounting
October 11, 2021 815-0622-00 REV 000 Itron, Inc. Page 13 of 99
DRAFT