Installation Guide

Push the end of the band through the band clamp screw assembly.
Turn the band clamp’s screw assembly to fit into the pipe bracket opening.
Tighten the clamp screw until the band clamp is secure on the pipe.
5. Place the adapter plate on the pipe bracket with the mounting lug at the top. The adapter
plate screw bosses fit into the pipe bracket recess.
6. Ensure that the adapter plate is positioned as shown with the mounting lug (1) at the top.
Install the adapter plate on the pipe mounting bracket, use the two shortest (1/2 inch)
screws from the pipe mount kit.
Place the mounting screws into the holes as shown (2).
Tighten both screws in an alternating pattern to 9 to 12 inch-pounds torque.
7. Position the back on the Cellular 500G against the face of the adapter plate. The adapter
plate mounting lug must be positioned above the module mounting lug recess.
8. Push up on the module until the adapter plate mounting lug is as far as possible inside the
module mounting lug recess.
9. Align the module backplate mounting holes with the pipe mount adapter plate holes. Install
the 2 one inch module mounting screws from the installation kit. Tighten the module
mounting screws evenly in an alternating pattern. Tighten the screws to 9 to 12 inch-
pounds torque.
Cellular 500G Module Remote Mount Installation Guide 2 Mounting
October 11, 2021 815-0622-00 REV 000 Itron, Inc. Page 14 of 99
DRAFT