Installation Guide
Table Of Contents
- Cellular 500G Module Remote Mount Installation Guide
- Contents
- New in This Document
- 1 Introduction
- 2 Mounting
- 3 Programming
- 4 Specific Meter Manufacturer Installation
- 5 Using Gel-cap Connectors to Complete Wiring Connections
- 6 Optional Sealant Application Instructions
- A Important Safety and Compliance Information
- U.S. and Canadian Patent Numbers
- USA, FCC Part 15 Spectrum Compliance
- Modifications, Repairs, Installation, and Removal
- Canada, ISED Spectrum Compliance
- RF Exposure (FCC/ISED)
- Transportation Classification
- Lithium Battery Safety
- Equipment Repairs
- Intrinsic Safety
- Electrostatic Ignition Hazard
- Module Cleaning
- Do Not Drop
10. Insert the tamper seals.
11. Gather the excess module cabling into a loop and use the cable tie to secure the gathered
cable to the pipe.
Adapter Plate Mounting Positions
Note: The notch at the top of the adapter plate (1) must always be at the top position. The
following illustrations show the various mounting configurations. The adapter plate
mounting screw locations are indicated (2).
45-degree angle with the pipe
running to the right
45-degree angle with the pipe running
to the left
Horizontal
Cellular 500G Module Remote Mount Installation Guide 2 Mounting
October 11, 2021 815-0622-00 REV 000 Itron, Inc. Page 15 of 99
DRAFT