Installation Guide
Table Of Contents
- Cellular 500G Module Remote Mount Installation Guide
- Contents
- New in This Document
- 1 Introduction
- 2 Mounting
- 3 Programming
- 4 Specific Meter Manufacturer Installation
- 5 Using Gel-cap Connectors to Complete Wiring Connections
- 6 Optional Sealant Application Instructions
- A Important Safety and Compliance Information
- U.S. and Canadian Patent Numbers
- USA, FCC Part 15 Spectrum Compliance
- Modifications, Repairs, Installation, and Removal
- Canada, ISED Spectrum Compliance
- RF Exposure (FCC/ISED)
- Transportation Classification
- Lithium Battery Safety
- Equipment Repairs
- Intrinsic Safety
- Electrostatic Ignition Hazard
- Module Cleaning
- Do Not Drop
1. Verify that you have the correct programming mode (Network Mode or Mobile Mode
[mobile high power mode, mobile/handheld mode, or hard-to-read mode]) for your
application.
2. For all programming and Check Endpoint operations using a handheld computer, hold
the handheld as close to vertical as possible. For best success, keep the handheld within
six feet of the target module.
3. Programming parameters are based on the configuration file loaded into the programming
device.
4. Read or Check the Cellular 500G using a compatible handheld computer.
–
If the read result is higher than the number programmed in step 1, the module is
counting correctly.
–
If the read result is not higher than the number programmed in step 1, replace the
Cellular 500G.
Itron Programs and Software Variables
This section defines and clarifies possible system variables you may encounter in
programming modules.
Field Deployment Manager (FDM)
The following tables illustrate various FDM programming configurations and the endpoint
response to each setting.
Cellular 500G Module Remote Mount Installation Guide 3 Programming
October 11, 2021 815-0622-00 REV 000 Itron, Inc. Page 19 of 99
DRAFT