Installation Guide
Table Of Contents
- Cellular 500G Module Remote Mount Installation Guide
- Contents
- New in This Document
- 1 Introduction
- 2 Mounting
- 3 Programming
- 4 Specific Meter Manufacturer Installation
- 5 Using Gel-cap Connectors to Complete Wiring Connections
- 6 Optional Sealant Application Instructions
- A Important Safety and Compliance Information
- U.S. and Canadian Patent Numbers
- USA, FCC Part 15 Spectrum Compliance
- Modifications, Repairs, Installation, and Removal
- Canada, ISED Spectrum Compliance
- RF Exposure (FCC/ISED)
- Transportation Classification
- Lithium Battery Safety
- Equipment Repairs
- Intrinsic Safety
- Electrostatic Ignition Hazard
- Module Cleaning
- Do Not Drop
10. Press the magnet hub down over the hub spacer as far as possible. The bottom of the hub
spacer may touch the index face. Turn the dial after magnet hub installation to verify that
the index dial functions with a smooth, easy rotation.
11. If the dial needle tip sticks out past the edge of the magnet hub, cut off the end of the dial
needle as close as possible to the magnet hub with sharp, side-cutting pliers.
12. Remove the acetone stick applicator from the remote encoder installation kit (Itron part
number CFG-0081-001). Select a location on the index face next to the magnet hub for the
encoder installation. After installation, the encoder cable must not interfere with the index
dials.
Cellular 500G Module Remote Mount Installation Guide 4 Specific Meter Manufacturer Installation
October 11, 2021 815-0622-00 REV 000 Itron, Inc. Page 28 of 99
DRAFT