Installation Guide

Meter model Meter notes Itron part number
MPplus volume corrector
Pulse width: 70 mS and 50 mS off timing
Pulse output board required
ERG-7000-502
XARTU-1 volume corrector
Pulse width: 70 mS on and 500 mS off timing
Corrector must have Solid State relays
Overview
Installing the Cellular 500G to an Eagle Research volume corrector involves four tasks.
1. Programming or verifying that the volume corrector is set up to work with the Cellular
500G.
Programming requires a computer loaded with the Eagle Research Software and an Eagle
Research computer-to-volume corrector communication cable.
2. Connecting the module to the volume corrector.
Requires a wire stripper and flat-tip screwdriver sized to tighten the terminal connections
on the Eagle corrector.
3. Mounting the Cellular 500G. Select the mounting option appropriate for your installation.
Mounting options include:
–
Wall mount on a sheet metal surface
–
Pipe mount using the Itron pipe mount kit CFG-0005-003
–
Custom Eagle Research mounting option using the Eagle research mounting rail
(Eagle Research part number 1010247.
Note: Itron recommends an optional sealant for installations where insect intrusion
may be a problem. For more information, see Optional Sealant Application
Instructions on page 94.
Cellular 500G Module Remote Mount Installation Guide 4 Specific Meter Manufacturer Installation
October 11, 2021 815-0622-00 REV 000 Itron, Inc. Page 34 of 99
DRAFT