Installation Guide
Table Of Contents
- Cellular 500G Module Remote Mount Installation Guide
- Contents
- New in This Document
- 1 Introduction
- 2 Mounting
- 3 Programming
- 4 Specific Meter Manufacturer Installation
- 5 Using Gel-cap Connectors to Complete Wiring Connections
- 6 Optional Sealant Application Instructions
- A Important Safety and Compliance Information
- U.S. and Canadian Patent Numbers
- USA, FCC Part 15 Spectrum Compliance
- Modifications, Repairs, Installation, and Removal
- Canada, ISED Spectrum Compliance
- RF Exposure (FCC/ISED)
- Transportation Classification
- Lithium Battery Safety
- Equipment Repairs
- Intrinsic Safety
- Electrostatic Ignition Hazard
- Module Cleaning
- Do Not Drop
3. Tighten the compression connector.
4. Connect the red Cellular 500G wire to pin 4 of the K2 terminal port.
5. Twist the Cellular 500G’s blue and white wires together and connect the twisted blue and
white wires to pin 5 of the K2 terminal port.
6. Plug the MTA battery connector from the battery pack into the VBAT1 connector to supply
power to the XARTU-1 corrector.
7. Close and latch the corrector door.
For XARTU-1 corrected reads
1. With the XARTU door open, insert the flying leads fro. The Cellular 500G into the
compression connector on the left of the corrector’s housing.
2. Pull the lead wires through the compression connector until there is adequate wire to
reach the K1 terminal port.
–
K1
–
K2
–
K3
3. Tighten the compression connector.
4. Connect the red Cellular 500G wire to pin 1 on the K1 terminal port.
5. Twist the Cellular 500G’s blue and white wires together.
Cellular 500G Module Remote Mount Installation Guide 4 Specific Meter Manufacturer Installation
October 11, 2021 815-0622-00 REV 000 Itron, Inc. Page 38 of 99
DRAFT