Installation Guide
Table Of Contents
- Cellular 500G Module Remote Mount Installation Guide
- Contents
- New in This Document
- 1 Introduction
- 2 Mounting
- 3 Programming
- 4 Specific Meter Manufacturer Installation
- 5 Using Gel-cap Connectors to Complete Wiring Connections
- 6 Optional Sealant Application Instructions
- A Important Safety and Compliance Information
- U.S. and Canadian Patent Numbers
- USA, FCC Part 15 Spectrum Compliance
- Modifications, Repairs, Installation, and Removal
- Canada, ISED Spectrum Compliance
- RF Exposure (FCC/ISED)
- Transportation Classification
- Lithium Battery Safety
- Equipment Repairs
- Intrinsic Safety
- Electrostatic Ignition Hazard
- Module Cleaning
- Do Not Drop
Using Eagle Research Field Manager to Change the MPplus Settings
1. Open the Eagle Research Field Manager from the Start menu or the desktop shortcut.
2. Connect the communications cable from your computer into the MS connector on the side
of the MPplus corrector. After the MS connector is connected, take note of the baud rate
displayed on the front of the corrector.
3. Click Connect on the upper left corner of the Field Manager window. A Connect to
Remote window opens.
4. Select the following parameters:
–
Connection Type: Direct
–
Communications Port: enter your computer’s port number
–
Baud Rate: enter the baud rate that displayed in Step 3.
5. Click OK.
6. Click View/Config.The Field Manager window opens and displays the settings for the
current connection.
Cellular 500G Module Remote Mount Installation Guide 4 Specific Meter Manufacturer Installation
October 11, 2021 815-0622-00 REV 000 Itron, Inc. Page 40 of 99
DRAFT