Installation Guide
Table Of Contents
- Cellular 500G Module Remote Mount Installation Guide
- Contents
- New in This Document
- 1 Introduction
- 2 Mounting
- 3 Programming
- 4 Specific Meter Manufacturer Installation
- 5 Using Gel-cap Connectors to Complete Wiring Connections
- 6 Optional Sealant Application Instructions
- A Important Safety and Compliance Information
- U.S. and Canadian Patent Numbers
- USA, FCC Part 15 Spectrum Compliance
- Modifications, Repairs, Installation, and Removal
- Canada, ISED Spectrum Compliance
- RF Exposure (FCC/ISED)
- Transportation Classification
- Lithium Battery Safety
- Equipment Repairs
- Intrinsic Safety
- Electrostatic Ignition Hazard
- Module Cleaning
- Do Not Drop
7. Click the Setup Parameters tab at the bottom of the parameters window.
A parameters window opens.
8. Enable POut 5 (17, 18).
9. Set the additional parameters as required in the Uncorrected Pulse Output Setup at the
lower right of the window.
10. If your software does not have an option to use POut for the uncorrected pulse output,
contact Eagle Research to get the correct software version.
11. Enter the parameters shown in the Corrected Pulse Output Setup section in the lower
left of the window.
12. Click Send All Changes.
13. Verify that all parameters are correct.
14. Click Disconnect.
Cellular 500G Module Remote Mount Installation Guide 4 Specific Meter Manufacturer Installation
October 11, 2021 815-0622-00 REV 000 Itron, Inc. Page 41 of 99
DRAFT