Installation Guide
Table Of Contents
- Cellular 500G Module Remote Mount Installation Guide
- Contents
- New in This Document
- 1 Introduction
- 2 Mounting
- 3 Programming
- 4 Specific Meter Manufacturer Installation
- 5 Using Gel-cap Connectors to Complete Wiring Connections
- 6 Optional Sealant Application Instructions
- A Important Safety and Compliance Information
- U.S. and Canadian Patent Numbers
- USA, FCC Part 15 Spectrum Compliance
- Modifications, Repairs, Installation, and Removal
- Canada, ISED Spectrum Compliance
- RF Exposure (FCC/ISED)
- Transportation Classification
- Lithium Battery Safety
- Equipment Repairs
- Intrinsic Safety
- Electrostatic Ignition Hazard
- Module Cleaning
- Do Not Drop
Important! Verify that the cable tie and gel connectors are inside the module
housing and that the cable extends out of the slot in the backplate. Torque the
backplate mounting screws to 9 to 12 inch-pounds.
Installing the Cellular 500G Cable
1. Insert the plug on the cable connected to the module into the receptacle on the meter
adapter plate.
2. Tighten the threaded collar on the plug onto the American Meter interface receptacle.
Verify that the connection is hand-tight.
Galvanic Gas Micro Installation
This section describes installation to Galvanic compatible correctors.
Cellular 500G Module Remote Mount Installation Guide 4 Specific Meter Manufacturer Installation
October 11, 2021 815-0622-00 REV 000 Itron, Inc. Page 49 of 99
DRAFT