Installation Guide

Meter model Meter notes Itron part
number
Module notes
Integral Micro Corrector MC2
Series 3 ES3 meter
Electronic Temperature Compensator (ETC)
Pulse width must be
set greater than 100
ms. Firmware
version 1.71 or
earlier.
ERG-7000-503
ERG-7000-505
Both modules are
compatible with
this meter model.
Overview
Installing the Cellular 500G to a GE Dresser meter involves the following tasks.
1. Programming or verifying that the meter is set up to work with the Cellular 500G.
–
Programming may require a computer and communication cable.
2. Wiring the GE-supplied cable to the module or wiring the module to the GE device.
Wiring may require a wire stripper, flat-tip screwdriver, Torx T-15 screwdriver, and wire
crimper. Requirements are dependent on your installation.
3. If your installation uses a GE supplied cable, connect the cable to the meter. If your
installation requires wiring directly to the GE device, move to the next step.
4. Mounting the Cellular 500G. For more information, see Mounting on page 12. Select the
mounting option appropriate for your installation.
–
Wall mount on a sheet metal surface
–
Pipe mount using the Itron pipe mount kit CFG-0005-003
Cellular 500G Module Remote Mount Installation Guide 4 Specific Meter Manufacturer Installation
October 11, 2021 815-0622-00 REV 000 Itron, Inc. Page 52 of 99
DRAFT