Installation Guide
Table Of Contents
- Cellular 500G Module Remote Mount Installation Guide
- Contents
- New in This Document
- 1 Introduction
- 2 Mounting
- 3 Programming
- 4 Specific Meter Manufacturer Installation
- 5 Using Gel-cap Connectors to Complete Wiring Connections
- 6 Optional Sealant Application Instructions
- A Important Safety and Compliance Information
- U.S. and Canadian Patent Numbers
- USA, FCC Part 15 Spectrum Compliance
- Modifications, Repairs, Installation, and Removal
- Canada, ISED Spectrum Compliance
- RF Exposure (FCC/ISED)
- Transportation Classification
- Lithium Battery Safety
- Equipment Repairs
- Intrinsic Safety
- Electrostatic Ignition Hazard
- Module Cleaning
- Do Not Drop
1 Top anchor screw positions
2 Bottom anchor position for the module U-shaped mount
Order the correct Sensus Sonix direct mount bracket for your installation requirements from
Sensus North American Gas Customer Service. (Brackets and mounting hardware are
ordered separately).
Sensus Sonix direct mount brackets* and mounting hardware
Sensus part number Description
60025-063-00000 1.5 inch foiled twisted pairs (FTP), 45 low tension (Lt), #3 Spg, 60Lt,
#4 Spg
60025-063-01000 2 inch 11BS, 2 inch FTP
60025-063-02000 30Lt, #1A Spg, 1.25 inch National Pipe Thread (NPT), #2 Spg, 20Lt
903376 #8-32 by 3/4 inch sterling silver Fillister-head screws (two required)
011-14-286-00 Rubber mounting washer (stabilizes bracket and Cellular 500G
assembly)
Installing the Cellular 500G on the Mounting Bracket
1. Place the module mounting bracket over the inlet or outlet pipe fitting on the Sonix meter.
(The default position is over the inlet connection. The inlet connection is the left side
connection looking at the front of the meter.)
2. Remove the four module backplate screws and turn the backplate so the module mounting
screw holes are to the top of the module (the arrow on the module label must point up).
Secure the module with the four module backplate screws that were previously removed.
3. Slide the mounting lug (now on the bottom of the module) over the bottom anchor. Insert
the two top module mounting screws and tighten in an alternating pattern.
Cellular 500G Module Remote Mount Installation Guide 4 Specific Meter Manufacturer Installation
October 11, 2021 815-0622-00 REV 000 Itron, Inc. Page 90 of 99
DRAFT