Installation Guide
Table Of Contents
- Cellular 500G Module Remote Mount Installation Guide
- Contents
- New in This Document
- 1 Introduction
- 2 Mounting
- 3 Programming
- 4 Specific Meter Manufacturer Installation
- 5 Using Gel-cap Connectors to Complete Wiring Connections
- 6 Optional Sealant Application Instructions
- A Important Safety and Compliance Information
- U.S. and Canadian Patent Numbers
- USA, FCC Part 15 Spectrum Compliance
- Modifications, Repairs, Installation, and Removal
- Canada, ISED Spectrum Compliance
- RF Exposure (FCC/ISED)
- Transportation Classification
- Lithium Battery Safety
- Equipment Repairs
- Intrinsic Safety
- Electrostatic Ignition Hazard
- Module Cleaning
- Do Not Drop
5
Using Gel-cap Connectors to Complete Wiring
Connections
This section provides the instructions to complete Cellular 500G to meter wiring connections.
Gel-cap connections require:
■
E-9R 3M
®
gel-cap crimping tool
■
3M gel-cap connectors (Itron part number CON-0023-001)
1.
Push the two wires into the connector as far as possible.
Caution: Do not strip insulation from the ends of the wires before inserting them
into the connector.
2. Place the connector and connector wires into the jaws of the crimping tool. Ensure that the
wires remain fully inserted in the connector.
3.
Squeeze the handles to crimp the connector. Apply pressure until the cap is fully seated
(at least three seconds)
October 11, 2021 815-0622-00 REV 000 Itron, Inc. Page 92 of 99
DRAFT