Installation Guide
Table Of Contents
- Cellular 500G Module Remote Mount Installation Guide
- Contents
- New in This Document
- 1 Introduction
- 2 Mounting
- 3 Programming
- 4 Specific Meter Manufacturer Installation
- 5 Using Gel-cap Connectors to Complete Wiring Connections
- 6 Optional Sealant Application Instructions
- A Important Safety and Compliance Information
- U.S. and Canadian Patent Numbers
- USA, FCC Part 15 Spectrum Compliance
- Modifications, Repairs, Installation, and Removal
- Canada, ISED Spectrum Compliance
- RF Exposure (FCC/ISED)
- Transportation Classification
- Lithium Battery Safety
- Equipment Repairs
- Intrinsic Safety
- Electrostatic Ignition Hazard
- Module Cleaning
- Do Not Drop
6
Optional Sealant Application Instructions
In areas where insect intrusion is a problem, Itron recommends an optional sealant to help
keep insects out of the module housing. The Itron-tested and approved sealant (Itron part
number ADH-5106-000) is used to seal gaps in Cellular 500G installations that can allow
insect intrusion.
1. Prepare the module for the sealant by verifying the application area is clean and dry.
Warning! Apply sealant in a well-ventilated area.
2. Itron recommends sealant application afte. The Cellular 500G is installed so the cable is in
the installation position. Use the sealant (ADH-5106-000) to fill the gap.
3. Use enough sealant to fill the gap. Wipe off any excess sealant and replace the cover on
October 11, 2021 815-0622-00 REV 000 Itron, Inc. Page 94 of 99
DRAFT