Installation Guide

turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
■
Reorient or relocate the receiving antenna.
■
Increase the separation between the equipment and receiver.
■
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
■
Consult the dealer or an experienced radio or TV technician for help.
Modifications and Repairs
To ensure system performance, this device and antenna shall not be changed or modified
without the express approval of Itron. Per FCC and ISED rules, unapproved modifications or
operation beyond or in conflict with these instructions for use could void the user’s authority to
operate the equipment.
Modifications, Repairs, Installation, and Removal
To ensure system performance, this device and antenna shall not be changed or modified
without the express approval of Itron. Any unauthorized modification will void the user’s
authority to operate the equipment, per FCC and ISED rules.
In the event of malfunction, all repairs should be performed by Itron. It is the responsibility of
users requiring service to report the need for service to Itron.
Canada, ISED Spectrum Compliance
Compliance Statement Canada Déclaration de Conformité
This device complies with Innovation, Science and
Economic Development Canada (ISED) license-
exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause
interference, (2) this device must accept any
interference, including interference that may cause
undesired operation of the device.
Under Innovation, Science and Economic
Development Canada (ISED) regulations, this radio
transmitter may only operate using an antenna of a
type and maximum (or lesser) gain approved for the
transmitter by Industry Canada. To reduce potential
radio interference to other users, the antenna type and
its gain should be so chosen that the equivalent
isotropically radiated power (e.i.r.p.) is not more than
that necessary for successful communication.
Le présent appareil est conforme aux CNR d’Industrie
Canada applicables aux appareils radio exempts de
licence. L’exploitation est autorisée aux deux
conditions suivantes: (1) l’appareil ne doit pas produire
de brouillage, (2) l’utilisateur de l’appareil doit accepter
tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le
fonctionnement.
Conformément à la réglementation d’Industrie Canada,
le présent émetteur radio peut fonctionner avec une
antenne d’un type et d’un gain maximal (ou inférieur)
approuvé pour l’émetteur par Industrie Canada. Dans
le but de réduire les risques de brouillage
radioélectrique à l’intention des autres utilisateurs, il
faut choisir le type d’antenne et son gain de sorte que
la puissance isotrope rayonnée équivalente (p.i.r.e.) ne
dépasse pas l’intensité nécessaire à ‘'établissement
d’une communication satisfaisante.
Cellular 500G Module Remote Mount Installation Guide A Important Safety and Compliance Information
October 11, 2021 815-0622-00 REV 000 Itron, Inc. Page 97 of 99
DRAFT