Users Manual

CAT2 Communications Module
ISED RSS-Gen Notice
“This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions:
(1) This device may not cause interference; and (2) This device must accept any interference, including interference that
may cause undesired operation of the device.”
“Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes :
1) l’appareil ne doit pas produire de brouillage; 2) l’appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d’en compromettre le fonctionnement.”
ISED Canada ICES-003 Compliance
“ CAN ICES-3 (B)/NMB-3(B)”
Additional testing, Part 15 Subpart B disclaimer
The Itron CAT1 modular transmitter is only FCC authorized for the specific rule parts (i.e., FCC transmitter rules) listed
on the grant, and that the host product manufacturer is responsible for compliance to any other FCC rules that apply to
the host not covered by the modular transmitter grant of certification. If the grantee markets their product as being Part
15 Subpart B compliant (when it also contains unintentional-radiator digital circuity), then the grantee shall provide a
notice stating that the final host product still requires Part 15 Subpart B compliance testing with the modular transmitter
installed.
Changes or modifications to this device not expressly approved by Itron,
Inc. could void the user’s authority to operate the equipment.
RF Exposure (FCC/ISED)
The user’s manual for any product that contains this module will contain the following text:
“This equipment complies with radiation exposure limits set forth as a mobile classification for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20 cm between the
radiator and your body. This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.”
In order to comply with FCC / ISED RF Exposure requirements, this device must be installed to provide at least
20 cm separation from the human body at all times.
“ Afin de se conformer aux exigences d'exposition RF FCC / ISED, cet appareil doit être installé pour fournir au
moins 20 cm de séparation du corps humain en tout temps.“
(The CAT2 module has been evaluated within the OW CAT-M1 host for RF exposure compliance)