User's Manual
Table Of Contents
- Contents
- Before You Begin
- CCU/Repeater Basics
- Planning a CCU/Repeater Installation
- Installing the CCU/Repeater
- Battery Care and Replacement
- Detailed CCU/Repeater Specifications
- Status and Diagnostics
- Index
Chapter 3 Installing the CCU/Repeater
30 CCU 100 and Repeater 100 Installation Guide
Proprietary and Confidential
3. If you are using a remote endpoint antenna, attach the endpoint antenna cable to the
connector on the top of the CCU/Repeater.
Important Using weatherproof tape, wrap the remote endpoint antenna connection
on the top of the CCU/Repeater. Wrap from the CCU/Repeater up to the antenna
cable.
4. If you are using an Ethernet backhaul, attach the Ethernet cable ensuring the weather-
tight connector is properly secured. If the Ethernet connection is not used, secure the
weatherproof cap.
5. The grounding lug should be attached to earth ground according to local codes.
Installing the Battery
To install the battery
1. Remove the battery cover by loosening the four screws securing it.
These are captive screws and do not need to be fully removed from the battery cover.