User's Guide
Table Of Contents
- ContentsTable of Contents
- 1 Itron Mobile Radio Compliance
- 1 Introduction
- 2 About Your Itron Mobile Radio
- 3 Daily Operation
- 4 LED Status Indicators
- 5 Communication Ports
- 6 Carrying the Portable Itron Mobile Radio
- 7 Installing the IMR-FT
- 8 Maintaining your Itron Mobile Radio
- 9 Storing Your Radio
- 10 Battery Basics
- 11 Safety
- 12 Troubleshooting
- 13 Optimizing Bluetooth® Performance
- 14 Itron Mobile Radio Capabilities and Limitations
5
Communication Ports
The Itron Mobile Radio has one micro-USB communication port under a protective rubber flap
on the side of the radio near the top.
Note: The USB cable supplied with the IMR-FT has a down-angle micro-USB connector to
facilitate proper cable management with the mounting jacket. Using a cable with a straight or
up-angle connector will put unnecessary stress on the radio USB port and may, over time,
lead to a poor cable connection.
In addition, the radio is equipped with an internal port for wireless Bluetooth
®
communications. If
communication is in place through Bluetooth, attaching the USB cable only provides power.
Communication may occur through Bluetooth while charging with the USB.
Note: Some Windows 7 or Windows 8 users may experience difficulty connecting to the
device via USB or may see a prompt to install an updated Texas Instruments driver for the
device. Download and install the Itron Mobile Radio USB driver available from Itron Access
at https://access.itron.com/ (available for registered users).
01 September 2020 815-0410-00 17