User's Guide

Figure 3 shows the back of the Mounting Jacket with the included mounting plate. The back of
the Mounting Jacket has four threaded screw holes arranged in the universal AMPS hole
pattern. Four screws are also provided with the Mounting Jacket. This allows the Mounting
Jacket to be mounted to a compatible vehicle device mount, such as a pedestal, partition, or
other vehicle structure. The vehicle device mount is supplied and installed by the user.
Included with the IMR-FT is a multipurpose mounting plate. The mounting plate can be attached
to the Mounting Jacket, and then to the vehicle in several ways. Two orientations of the mounting
plate on the Mounting Jacket are shown below.
Vertical Mounting Plate
Horizontal Mounting Plate
■
Eight holes in a rectangle are arranged in the universal AMPS hole pattern in two directions,
allowing the Mounting Jacket to be attached in either a horizontal or vertical orientation.
■
Two through-holes in the ends of the mounting plate allow the plate to be attached to a
structure in the vehicle with up to ¼-inch bolts or other fasteners (not supplied by Itron).
■
Six slots on the sides of the mounting plate allow the plate to be attached to a structure in the
vehicle with locking cable ties or other fasteners (not supplied by Itron).
01 September 2020 815-0410-00 28
Itron Mobile Radio User Guide Chapter 7 Installing the IMR-FT