User's Guide

2. Carefully feed the connector and coaxial cable through the hole from the top side and
thread it out of the headliner near the IMR-FT mounting location.
3. Insert the rest of the cable and the lower tabs of the mount body through the hole from the
top.
4. Center the mount body in the hole.
5. Ensure that the rubber O-ring is pressed into the groove in the brass nut and thread the nut
onto the mount body.
6. Finger-tighten the nut and then use a wrench to tighten the nut until the O-ring is
compressed. If the mount body spins while you are tightening the nut, use a spanner
wrench applied to the two holes on the top of the mount body to hold it still.
7. Clean the surface of the vehicle around the antenna mount body.
8. Ensure that the gasket is properly set in the antenna base.
9. Thread the antenna base onto the mount body, making sure not to cross-thread the
mount.
10. Continue tightening the antenna base until it seats to the vehicle.
11. Complete the cable routing to the IMR-FT in the vehicle and secure the cable.
19 October 2021 815-0410-00 REV 001 24
Itron Mobile Radio User Guide Chapter 7 Installing the IMR-FT