User's Guide
Table Of Contents
- ContentsTable of Contents
- Itron Mobile Radio Compliance
- 1 Introduction
- 2 About Your Itron Mobile Radio
- 3 Daily Operation
- 4 LED Status Indicators
- 5 Communication Ports
- 6 Carrying the Portable Itron Mobile Radio
- 7 Installing the IMR-FT
- 8 Maintaining your Itron Mobile Radio
- 9 Storing Your Radio
- 10 Battery Basics
- 11 Safety
- 12 Troubleshooting
- 13 Optimizing Bluetooth® Performance
- 14 Itron Mobile Radio Capabilities and Limitations
Figure 1 shows the back of the Mounting Jacket with the included mounting plate. The back of
the Mounting Jacket has four threaded screw holes arranged in the universal AMPS hole
pattern. Four screws are also provided with the Mounting Jacket. This allows the Mounting
Jacket to be mounted to a compatible vehicle device mount, such as a pedestal, partition, or
other vehicle structure. The vehicle device mount is supplied and installed by the user.
Included with the IMR-FT is a multipurpose mounting plate. The mounting plate can be
attached to the Mounting Jacket, and then to the vehicle in several ways. Two orientations of
the mounting plate on the Mounting Jacket are shown below.
Figure 4Vertical Mounting Plate
Figure 5Horizontal Mounting Plate
■
Eight holes in a rectangle are arranged in the universal AMPS hole pattern in two
directions, allowing the Mounting Jacket to be attached in either a horizontal or vertical
orientation.
■
Two through-holes in the ends of the mounting plate allow the plate to be attached to a
structure in the vehicle with up to ¼-inch bolts or other fasteners (not supplied by Itron).
19 October 2021 815-0410-00 REV 001 30
Itron Mobile Radio User Guide Chapter 7 Installing the IMR-FT