User's Guide

■
Six slots on the sides of the mounting plate allow the plate to be attached to a structure in
the vehicle with locking cable ties or other fasteners (not supplied by Itron).
Warning! The primary consideration when installing the IMR Mounting Jacket is
that the IMR be securely attached to the vehicle. Failure to do so could lead to injury
or death from unsecured components during a sudden stop, rollover, or collision.
The following procedures describe several possible mounting configurations.
Installing on a Lap Seat Belt
Attach the Mounting Jacket to the lap seat belt using the seat belt retaining flap as shown
below. The Mounting Jacket may be installed with the top of the jacket facing either way.
Warning! For safety, the Mounting Jacket should only be attached to a lap seat
belt., Attaching it to a shoulder belt may allow the IMR-FT to swing unrestrained,
causing a potential hazard.
Caution: When the IMR-FT is installed on a lap seat belt, do not place other items
on top of the IMR-FT or its cables. Do not allow passengers to sit on the IMR-FT or
to wear a seat belt with an IMR-FT attached to it.
Installing on a Partition or Other Vehicle Structure
1. Attach the supplied mounting plate to the Mounting Jacket in the orientation most useful
for your purpose using the screws supplied by Itron. Torque the screws to 17-19 in. lbs.
19 October 2021 815-0410-00 REV 001 31
Itron Mobile Radio User Guide Chapter 7 Installing the IMR-FT