User's Guide
Table Of Contents
- ContentsTable of Contents
- Itron Mobile Radio Compliance
- 1 Introduction
- 2 About Your Itron Mobile Radio
- 3 Daily Operation
- 4 LED Status Indicators
- 5 Communication Ports
- 6 Carrying the Portable Itron Mobile Radio
- 7 Installing the IMR-FT
- 8 Maintaining your Itron Mobile Radio
- 9 Storing Your Radio
- 10 Battery Basics
- 11 Safety
- 12 Troubleshooting
- 13 Optimizing Bluetooth® Performance
- 14 Itron Mobile Radio Capabilities and Limitations
2. Using cable ties, two ¼-inch bolts, or some other secure fasteners, attach the mounting
plate to the vehicle partition or other suitable vehicle structure. (Fasteners are not supplied
by Itron.)
Installing on a Pedestal
Attach the Mounting Jacket to a pedestal device mount with the screws supplied by Itron.
Torque the screws to 17-19 in. lbs.
The pedestal device mount must match the universal AMPS hole pattern used by the
Mounting Jacket. (Itron does not supply pedestal device mounts.)
Installing the IMR-FT in the Mounting Jacket
1. Place the IMR-FT in the Mounting Jacket and engage the plastic side release buckles.
2. Ensure the IMR-FT is securely enclosed in the Mounting Jacket and tighten the straps, if
necessary.
3. After installing the IMR-FT in the Mounting Jacket, plug the micro-USB cable into the IMR-
FT and secure the cable with the cable retaining flap.
4. Attach the DC power cable and antenna cable to their connectors on the charge base.
Note: The DC power cable connector and antenna cable connector should only be
finger tightened. Do not tighten the connectors with a tool.
When complete, your IMR-FT installation should look like this:
Removing the IMR-FT from the Mounting Jacket
1. Disconnect the DC power cable and the antenna cable from the bottom of the IMR-FT.
2. Unplug the micro-USB cable and open the Velcro cable retaining flap.
19 October 2021 815-0410-00 REV 001 32
Itron Mobile Radio User Guide Chapter 7 Installing the IMR-FT