User's Guide

Itron Mobile Radio Compliance
Equipment description
Itron Mobile Radio
IMR Model: FCC ID: ISED, IC: ISED, HVIN:
IMR EO9IMRA 864A-IMRA IMRA
IMR 2 EO9IMRB 864A-IMRB IMRB-INT
IMR-FT EO9IMRB 864A-IMRB IMRB-EXT
IMR 2.1 EO9IMRC N/A N/A
IMR-FT 2.1 EO9IMRC N/A N/A
IMR 2.2 EO9IMRD 864A-IMRD IMRD-INT
IMR-FT 2.2 EO9IMRD 864A-IMRD IMRD-EXT
FCC USA intentional radiator compliance statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause
undesired operation.
FCC USA un-intentional radiator compliance statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
■
Reorient or relocate the receiving antenna.
■
Increase the separation between the equipment and receiver.
■
Connect the equipment into an outlet on a circuit different from that to which the receiver is
19 October 2021 815-0410-00 REV 001 Itron, Inc. Page 5 of 52