User Manual

CAM Installation
for RF Only Applications
OpenWay® Riva™ CAM / ACT Coupler Unit 7
Install CAM for RF Only Applications
Illustration Callout Number Description
1
Slot #5 identifier label
2
CAM (OW1)
3
CAM retaining screws
1. Locate slot #5 by the slot identifier label inside the CGR.
2. Insert the CAM in slot #5 of the CGR. Ensure the CAM is oriented so that the connectors on the rear of
the CAM are aligned with those in the slot #5. Gently press the CAM until the card-edge connector on the
CAM is firmly seated into the connector in the CGR.
3. Tighten the retaining screws on the front of the CAM securing the module in place. Use either a #2
Phillips or a 9/32" flat blade screwdriver.