Datasheet

82
82
awww.ittcannon.com
Dimensions shown in mm (inch)
Specifications and dimensions subject to change
Shielded Endbell for
Larger Cable Sizes
This Endbell is an alternative to the
Universal Endbell for use with larger
diameter cables. The outer body is sealed
to the connector with an O-ring and the
rear cable clamp also incorporates sealing
rings for a complete sealed termination.
The cable braid is terminated between
metal cones. A rear cable clamp provides
mechanical strain relief in addition to the
clamping and holding of the rear cable
seal.
Assembly Instructions:
1. Assemble all parts onto the cable as
shown (Figure 1). Strip sheath of cable to
dimensions shown in table below.
Dimension
Shell Size A min.
10 22,30 (.877)
12 22,30 (.877)
14 26,20 (1.031)
16 28,10 (1.106)
2. Fold braid back over cable. Strip and
terminate wires with selected contacts
(Figure 2).
3. Assemble O-ring in groove of the shell
after positioning coupling nut (Figure 3).
Cable Sizes
Endbell Cable Outer Sheath Diameter
Shell Size Part Number Maximum Minimum
10 192993-0091 10,00 (.393) 5,00 (.196)
12 192993-0092 12,00 (.472) 6,00 (.236)
14 192993-0093 14,00 (.551) 7,00 (.279)
16 192993-0094 16,00 (.629) 8,00 (.314)
Wire Stripping Lengths
Contact Type Wire Size Wire Range mm2 Dimension B
Formed 24-16 AWG 0,08 - 1,50 3,95 ± 0,25 (.155 ± .009)
contact 14 AWG 1,50 - 2,50 5,60 ± 0,25 (.220 ± .009)
Machined 26-20 AWG 0,08 - 0,64 5,08 ± 0,25 (.200 ± .009)
contact 16 AWG 0,60 - 1,51 7,11 ± 0,25 (.279 ± .009)
Figure 3
Figure 1
Figure 2
Assembly Instructions
Cannon Trident Connectors