Datasheet

83
www.ittcannon.com
Dimensions shown in mm (inch)
Specifications and dimensions subject to change
Shielded Endbell for
Larger Cable Sizes
(continued from page 82)
4. Fold braid forward as shown and trim
to length (Figure 4).
5. Slide on clamp ring in position shown
(Figure 5).
6. Screw clamp body onto the connector
using a strap wrench (Figure 6). Tighten
to the recommended torque values in
table below.
Shell Clamp body
Size Torque max.
10 4 Nm
12 6 Nm
14 10 Nm
16 10 Nm
7. Push metal washers and rubber washer
into rear of clamp body. Then screw
compression nut to compress rubber
washer. Avoid overtightening as this may
twist the cable. Finally tighten screws to
provide the mechanical strain relief
(Figure 7).
8. Assembled connector (Figure 8).
Assembly Instructions
Cannon Trident Connectors