Operation Manual

Note:
To make a call to the last number you dialed, use the Redial feature. For details, see par. Last
Number Redial.
You can enter the desired phone number in standby mode, which allows you to make
corrections before dialing. Follow these steps:
1. Enter a telephone number (up to 32 digits). Check it. You can also use the key to insert a
pause.
Note:
If you make a mistake while entering a number, press the Erase soft key to clear the last digit.
2. When the number appears correctly, press the key.
Receiving a Call
When a new call is received, the call information will appear. If the caller can be identified, the
caller's phone number is displayed. If the caller cannot be identified, only the New Call
information displays. If you have a voice message, the icon and "MSG WTG ON" will be
shown on the LCD.
1. To answer the call, press the key. If you have activated the Auto Answer function, when
the handset is on the base, simply lift it up to answer.
2. To end the call, either press the key or replace the handset on the base.
Result: After you hang up the call, the LCD displays the call duration.
Notes:
You can select the ringer volume by using or key when the phone rings with an
incoming call.
If you want to deactivate the icon, press the key in standby mode, then press and hold
the key. After that, press the key to return to standby mode. (The handset must be
registered to the base.)
If the polyphonic ring tone is set, the ring tone may continue for 4 seconds after the caller's
hang-up or after the parallel phone had answered the call.
Muting the Microphone
During a conversation, you can temporarily switch your phone's microphone off, so that the
other party cannot hear you.