Operation Manual

1. In the standby mode, press the key.
2. Press or key repeatedly until the desired number is displayed.
Dialing from One-touch Memories
In the standby mode, press M1, M2 or SOS to dial out the corresponding number.
Editing Memory Numbers
Perform the steps of par. Editing the Phone book Entries.
Note:
The memory default names are M1, M2 and SOS, you can add a name after them but cannot
delete the default name. e.g. you can modify M1 to M1: home.
Deleting Memory Numbers
Perform the steps of par. Deleting the Phone book Entries.
BS Settings
Terminate HS
This function allows you to delete a handset registration from the base.
1. Press the Menu soft key.
2. Press or key to choose BS Settings, then press the Select soft key.
3. Press the Select soft key to choose the Terminate HS menu. The display shows "PIN?" to
prompt you to enter the PIN Code (The default PIN Code is "0000"). Then press the OK soft
key.
4. Use or key to select a handset. If you select the current handset or a non-existent
handset, a warning tone will be heard.
5. Press the Select soft key to confirm, and the selected handset will behave according to the
unregistered condition.
Flash Time
You can select to change the Flash time by the following steps:
1. Press the Menu soft key.