Operation Manual

Charging Handset
Using Headset (optional)
3. To replace the battery cover, slide the cover up until it snaps in
place.
Notes:
Reversing the orientation may damage the handset.
The batteries need to be replaced if they do not recover their full
storage capacities after recharging.
When replacing the batteries, always use good quality Ni-MH
re-chargeable batteries. Never use other batteries or conventional
alkaline batteries.
! Important Note: Before initial operation, YOU SHOULD
FULLY CHARGE THE HANDSET for about 15 hours.
To charge the handset, you should place it on the base.
Result: When you place the handset on the base, the handset
automatically turns on.
Headset Jack
Earphone
Microphone
Clip
The headset jack is located in the left side of
the handset and is 2.5mm standard plug.
Simply plug the headset into this jack and
the headset will be activated.
Note:
When the headset is plugged into the
headset jack, the microphone on the handset
will be deactivated.