Owner Manual

Troubleshooting

If you experience issues with your device, please check the following:

1. Make sure the unit is plugged in properly and turned on via the ON/OFF switch on

the back.

2. Make sure the wall outlet to which the power cable is connected is an active outlet that

is working properly.

3. Make sure that the ozone plates are clean and dry without any cracks. Ozone plates

generally need to be cleaned about once a month. Environmental factors such as pet

dander, cigarette smoke, etc., can aect the duration of ozone output. It’s optimal to

replace the ozone plates once every six months. Clean or change your ozone plates

more often if ozone output is weak. Follow these steps to check your ozone plates:

a. Make sure the ozone air puriﬁer is o and disconnected from the

power supply.

b. Flip the unit over so the handle is on the bottom. You will see two

screws toward the front plate of the device. Remove those two

screws with a Philips-head screwdriver.

c. Remove the bottom plate. You should see a piece of white plastic

material with a black honeycomb pattern on it, held in place by a

black clip at the top. Press back on the clip until it releases the

plate and you can pull the white plastic ozone plate toward you

without bending it.

3. Turn the timer knob clockwise to set the timer for up to 120 minutes. Please refer to the

table below for a general guideline about operation time in relation to room size.

NOTE: For very large spaces, you can turn the timer knob to HOLD to make the unit run

indeﬁnitely. Please note the unit is designed to operate in unoccupied spaces only. If you

turn the timer knob to HOLD, the unit will continue operating until someone quickly

comes in, turns it o, and then leaves the space again.

4. As soon as you set the timer, the machine will begin generating ozone. Leave the

room immediately.

5. Wait for the timer to run out and the machine will automatically deactivate. If the HOLD

override is in operation, wait for someone to deactivate the unit.

6. Once the machine is deactivated, wait at least another hour before re-entering the room,

so the ozone molecules have enough time to revert to oxygen molecules.

7. Enter your room after at least an hour and enjoy the fresh, clean air! (Please note, a slight

“electrical” odor in the air is normal; ozone has its own distinctive scent that will fade.)

Room

ize

100 ft 200 ft 500 ft 1000 ft 2500 ft 4000 ft

Run Time

5 min 10 min 32 min 60 min 120 min Hold