Data Sheet

Data Sheet
6141 Running Springs Rd
San Jose, CA 95135
www.ivativ.com
Email: [e-mail]
Ph.: [phone]
Page 12 of 24
August 3, 2022
5.3 Performance specifications
5.3.1 Radio performance specifications
5.3.1.1 General radio characteristics
Symbol
Description
Min.
Typ.
Max.
Units
f
op
Operating frequencies
2360
2500
MHz
f
PLL,CH,SP
PLL channel spacing
1
MHz
f
DELTA,1M
Frequency deviation @1 Mbps
±170
kHz
f
DELTA,BLE,1M
Frequency deviation @BLE 1 Mbps
±250
kHz
f
DELTA,2M
Frequency deviation @2 Mbps
±320
kHz
f
DELTA,BLE,2M
Frequency deviation @BLE 2 Mbps
±500
kHz
fsk
BPS
On-the-air data rate
125
2000
kbps
Table 4: General radio characteristics
5.3.1.2 Receiver characteristics
Symbol
Description
Min.
Typ.
Max.
Units
P
RX,MAX
Maximum received signal strength at < 0.1% PER
0
dBm
P
SENS,IT,1M
Sensitivity, 1 Mbps nRFmode ideal transmitter
18
-93
dBm
P
SENS,IT,2M
Sensitivity, 2 Mbps nRF mode ideal transmitter
19
-89
dBm
P
SENS,IT,SP,1M,BLE
Sensitivity, 1 Mbps BLE ideal transmitter, packet
length ≤ 37 bytes BER=1E-3
20
-95
dBm
P
SENS,IT,LP,1M,BLE
Sensitivity, 1 Mbps BLE ideal transmitter, packet
length ≥ 128 bytes BER=1E-4
21
-94
dBm
P
SENS,IT,SP,2M,BLE
Sensitivity, 2 Mbps BLE ideal transmitter, packet
length ≤ 37 bytes
-92
dBm
P
SENS,IT,BLE LE125k
Sensitivity, 125 Kbps BLE mode
-103
dBm
P
SENS,IT,BLE LE500K
Sensitivity, 500 Kbps BLE mode
-99
dBm
Table 5: Receiver characteristics
18
Typical sensitivity applies when ADDR0 is used for receiver address correlation. When ADDR [1...7] are
used for receiver address correlation, the typical sensitivity for this mode is degraded by 3 dB
19
Typical sensitivity applies when ADDR0 is used for receiver address correlation. When ADDR [1...7] are
Used for receiver address correlation, the typical sensitivity for this mode is degraded by 3 dB