Installation Guide
3
Leading the Way
IVC US Residential Installation Guide – Sheet Vinyl Flooring
• Duck Acrylic Double Face Tape for Vinyl Floors
• Sharp Utility Knife
• Straight edge
• Push broom
• IVC FLEX -PRIM Acrylic Latex Primer (if priming the oor is necessary)
Acceptable Underlayments
• Wood underlayment
Wood underlayment panels must be underlayment grade as specied and warranted
by the manufacturer. Always fasten underlayment panels in accordance with the manu-
facturer’s recommendations. Any failure of the underlayment or IVC US ooring as a
result of the underlayment is NOT the responsibility of IVC US.
• Concrete
• VCT (well bonded, on and above grade)
• Ceramic (well bonded) with a skim coat
• Terrazzo (well bonded)
• Self-leveling and patching compounds (latex fortied Portland cement based only)
• Resilient oor (no more than 2 layers, well bonded, non-cushioned – residential
applications only)
• Radiant heat oors (not exceeding 85°F (29°C) and approved by the manufacturer for
the use of their product with resilient vinyl ooring applications)
• Gypcrete can be utilized when necessary due to radiant heat and in high rise buildings.
Gypcrete must be sealed using IVC FLEX-PRIM Acrylic Latex Primer to stabilize the sur-
face for adhesive bond. All issues with gypcrete cracking, crumbling, powdering and
resulting in the release of adhesive bond are NOT warranted by IVC US.
• OSB (underlayment grade)
OSB underlayment panels must be underlayment grade as specied and warranted by
the manufacturer. Underlayment panels and joints must be fastened and reinforced ac-
cording to manufacturer’s instructions. Completely sand the oor with a oor sander, so
that the oor is smooth and at. NOTE: The chips in OSB overlap. Without sanding
properly, OSB has high and low spots throughout the oor that could telegraph
through the vinyl.
- Surface must be primed using IVC FLEX-PRIM Acrylic Latex Primer.
• Particle board (underlayment grade)
Particle board underlayment panels must be underlayment grade as specied and
warranted by the manufacturer.
- Surface must be primed using IVC FLEX-PRIM Acrylic Latex Primer.
Floor Preparation
Floor must be clean, smooth, at and dry. Remove all foreign substances such as wax,
grease, dirt, construction markings and contaminants, and any substance or chemical that
would interfere with a good bond. Fill all holes and cracks with a latex fortied Portland
cement based patching compound. Sand high spots to eliminate the possibility of tele-
This document is reviewed on an ongoing basis. Control # MKF_0012_0 8/13/13