Installation Guide

Additional Instructions/Notes:

• Always inspect the ooring thoroughly before installation.

• DO NOT slide heavy appliances or furniture over or across the ooring. Always lift objects and place them on

a hard board between the ooring and object and gently reposition them.

• Use caulk next to bathtubs, showers, sliding doors, patio doors, around metal door jambs or similar areas.

• For bathroom installations, it is not necessary to remove the toilet. Make relief cuts around the perimeter

of the toilet and make sure the vinyl ooring is laying at before trimming o󰮏 the excess material. Apply

permanent exible caulk around the toilet, next to the bathtubs and showers to prevent moisture from

getting under the vinyl. NOTE: if there is a ceramic sanitary cove and no place to install trim mold, you can

apply silicone caulk around the walls.

• Make sure furniture legs have large surface, non-staining plastic oor protectors or non-staining felt pads.

The protectors should be at least one inch in diameter and rest at on the oor. The heavier the item, the

wider the oor protector should be. Replace small, narrow metal or dome-shaped glides with smooth, at

glides that are in at contact with the oor.

• Never tape around the perimeter of the room.

Reversed Installation Guide

If there is a question as to what is considered an allover patter design, please contact Technical Services at

888-225-8287.

Residential Installation Guide – Sheet Vinyl Flooring

This document is reviewed on an ongoing basis. 4/22/14