User Manual

ENGLISH

RESTARTING THE ENGINE AFTER A LONG

PERIOD OF INACTIVITY

1. Drain the residual 30/M protective oil from the sump.

2. Fill the engine, as prescribed, with lubricant of the type and amount

indicated in the table REFUELLING.

3. Drain the CFB protective fluid from the fuel circuit, carrying out this

operation as indicated under point 3. of PREPARING THE

ENGINE FOR A LONG PERIOD OF INACTIVITY.

4. Remove the plugs and/or seals from the suction, delivery,

ventilation and bleeder openings in the engine, restoring it to a

normal state of use. Connect the turbocharger suction inlet to the

air filter.

5. Connect the fuel circuits to the vessel’s fuel tank, completing the

operations as indicated in point 4. of PREPARING THE ENGINE

FOR A LONG PERIOD OF INACTIVITY. During filling operations,

connect the fuel return pipe to a collection tank, so as to prevent

any residual CFB protective fluid from flowing into the vessel’s fuel

tank.

6. Check the engine and fill it up with coolant as prescribed.

7. Start the engine and keep it running until the idling speed rate has

stabilised completely.

8. Check that the instruments on the on-board control panel/s are

showing plausible values, and that no alarms are shown.

9. Stop the engine.

10.Remove the ENGINE WITHOUT OIL signs from the engine and

from the on-board control panel.