Caution: You must read this before you proceed.
Before Beginning Assembly: Unpack all the parts for a clear overview. Overview Table Top(A) Leg Panel(B) Leg Support Panel(C) This Table has multiple parts and may require up to some 30 minutes to assemble. To give you an overview of the Table parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly.
Step 1 Open the carton and place all the parts on a clean, non-marring surface. Turn table top upside down,then attach Leg Panels (B) to the Table Top(A) using Bolt(③) and Washer(②) with Allen Key(①) as shown in the picture above. Repeat this process with the other Leg Panel (B) Do not fully tighten the Bolts. Step 2 Attach Leg Support Panel(C) between Leg Panels(B) using Bolt(③) and Washer(②) with Allen Key(①) as shown in the picture above.
Step 3 Place the Table on a LEVEL SURFACE to check for wobbles. If it wobbles, apply steady and even pressure down on the Table with the help of an adult partner. Adjust the Legs Pre-installed Levellers until the Tables level with the ground. Adjust the levellers to the desired height to avoid wobbles. When the Table is level proceed to tighten all Bolts at all joints. CAUTION : When tightening these bolts, tighten sequentially. DO NOT tighten any screw fully and then towards the next one.
Questions & Answers about Proposition 65 • What is Proposition 65? Proposition 65 requires businesses to provide warnings to Californians about significant exposures to chemicals that cause cancer, birth defects or other reproductive harm. These chemicals can be in the products that Californians purchase, in their homes or workplaces, or that are released into the environment.
