Installation & Assembly

Place the Chair on a LEVEL SURFACE to check for wobbles.
If it wobbles lift the Chair some 30cm to 50cm high from the ground.
Keep your feet and toes well away from the drop zone.
Drop the Chair freely and vertically with the four legs, hitting the ground, all at the
same time.
This Drop Test will help to ensure that all the Bolts and gaps reach full alignment
status.
Test again for evenness on a LEVEL SURFACE.
If no wobbles are found, slowly and steadily, turn the Chair upside down.
Then, proceed to tighten all Bolts in a sequential manner.
When tightening the Bolts, tighten sequentially.
DO NOT tighten any Bolt fully and then move on towards the next one.
This would cause the frame to warp.
If there are still wobbles, loosen the Bolts and execute this same drop test.
Step 8
Put the Cushion(E) on the Chair.
Your Chair is ready for use.
This Chair can only be used on a flat, level surface.
Page 5 OF 6